Akkor neked is leírom, hogy az kevés, hogy álló helyben kiméred:
TESTER)
(a) Check that the ABS warning light is blinking as
shown in the illustration.
(b) Check the speed sensor signal.
(1) Drive the vehicle straight forward at a speed of
28 mph (45 km/h) or more for several seconds.
(2) Check that the ABS warning light goes off.
HINT:
• The sensor check may not be completed if
one or more wheels spin or the steering
wheel is turned.
• If the speed sensor check is commenced
while the steering wheel is turned, the ABS
warning light may come on after the low
speed check is finished.
• The ABS warning light comes on immediately
when an abnormality is detected.
• When the speed sensor signal is normal, the
ABS warning light goes off while the vehicle is
driven at 28 mph (45 km/h) or more and
blinks in the test mode pattern while
stationary.
• Do not drive the vehicle at a speed of 50 mph
(80 km/h) or more after the ABS warning light
turns off, because test mode DTCs are set
again when the vehicle speed exceeds 50
mph (80km/h).
Sziasztok! Yaris II-ben világít az ABS visszajelzője menet közben, és persze nem is működik. A biztosíték jó. Mérjem ki a jeladókat, vagy elég a tisztítás is?
Rengeteg dolog lehet, ha beviszed márkaszervízben ott computerrel elég hamar meg tudják állapítani a hibát. Bármi lehet, jeladók, vezetékek, ABS ECU. Otthon max annyit tehetsz, hogy kiméred a jeladókat. Tisztítással nem sokat érsz, nem jellemző az ilyen probléma, eddig még csak egy nagyon durván használt Hiluxnál kellett ilyen csinálnom.